升降平臺廠家http://www.briarcliffofwilson.com/介紹繞線式電動機的電刷，在長期運行中由于磨損使接觸面不平、電刷壓力不夠、滑環不圓，或因軸承上的油滴或其它雜物落到滑環與碳刷之間等原因，均會造成電刷冒火花。遇到這種問題時我們應該積極采取措施進行處理，以防引起更大的危害。
Lifting platform manufacturers introduced around the line motor brush, in the long run due to wear of the contact surface is uneven, brush pressure is not enough, slip ring round, or because of the bearing oil droplets or other debris fall between the slip ring and carbon brush, etc. reason, will cause the brush sparks. In this problem, we should take measures to deal with, in order to prevent more damage.

升降平臺廠家http://www.briarcliffofwilson.com/提醒大家消除電刷冒火花的方法，可用細砂紙將接觸面磨光，適當調整電刷的壓力，并檢查滑環是否圓，還應用干凈的棉紗稍蘸汽油擦凈滑環和碳刷，消除軸承及碳刷上的油污，做好滑環與碳刷的防護措施。
Lifting platform manufacturers remind you eliminate brush sparks, usable fine sandpaper to contact surface polishing, properly adjust the brush pressure, and inspection of the slip ring whether round, also with a clean cotton slightly dipped in gasoline rub net slip ring and carbon brush, eliminate oil bearing and a carbon brush, slip ring and carbon brush protective measures.